PAM Powder Dosing System for Sludge Flocculation
Product Description
Product Introduction
BOEEP automatic PAM powder dosing system is an automatic device for continuous preparation and addition of polymer solutions. Its raw material is dry powder. It completes the chemical combination and mixing continuously and efficiently, so as to obtain homogeneous and active polymer solution. The equipment can be widely used in municipal sewage treatment, sewage treatment plants, paper mills and other processing industries.
Structure & Features
BOEEP PAM powder dosing system consists of polymer feed device ( including material hopper), dry powder infiltration device, tank, level controller, mixer, dosage water inlet pipe, electric control panel.
Polymer dosing device
Polymer dosing device is composed of hopper, push screw, electric heater and etc. The effective volume of the hopper can meet the dosage for a long time which is equipped with sight glasses for observing material level monitored by the dry powder level meter. The push screw driven by the high-precision reducer can satisfy the dosage. The electric heater can installed in the discharge pipe of push screw, and it can prevent the powder from caking.
Polymer dissolving device
Polymer dissolving device is composed of pre-soaking device, tank, and 3 sets of mixers. The pre-soaking device is to infiltrate and mix the polymer powder in advance. The 3 tanks are precast mixing tank, homogeneous slaking tank and solution storage tank, in which there is a mixer correspondly to guarantee the homogeneity.
Water supply device
Water supply device is composed of pipeline, manual ball valve, filter, pressure gauge, solenoid valve, stop valve, and the rotor
flow meter, etc.
Technical Parameter
| Model：YTH4000 | Polymer feed diameter：DN40 |
| Polymer feed capacity：3.5-20kg/h | Vent pipe diameter：DN40 |
| Preparation capacity：4000L/h，curing time: 60min | Overflow pipe：DN40 |
| Dosing motor power：0.18KW | Dosage water inlet flow：2.4-12 m³/h |
| Mixer motor power：1.5KW(380V，50Hz)1set,1.1KW(1.5KW(380V，50Hz)2sets | Inlet pressure：0.2-0.3MPa |
| Electric heating power：0.02KW | Outline dimension：2700mm(L)×1400mm(B)×2250m(H) |
| Dosage water inlet diameter：DN50 | Main power：3.9KW |
Main Features
Optional: Vacuum feeding machine.
Optional: on-line dilution system.
Tank material: SS304 or SS316l, Polypopylene PP, FRP etc.
Full automatic operation including automatic dosing, dissolving and feeding.
The highly precise dry polymer dosing device and the well designed heater device can prevent the polymer from caking.
The dosage of dry powder and water can be adjustable, so the solution with any concentration can be prepared.
Technical Specification
Product Details
Object Site